Receive a Product Authorization Key (PAK) either by email or by physical mail.Purchase the license from your Cisco vendor.The licensing procedure goes in the following order: If you have not added any licenses, you will see a blank panel with the only option “Add New License” option. In ASDM, choose Configuration – ASA FirePOWER Configuration tab on the lower left corner and click “Licenses”. If you could not find the FirePOWER Configuration option and see the warning message under ASA FirePOWER Status tab, that’s because you logged in using an account without privilege 15. To configure the FirePOWER module, you must login ASDM with an ASA username that has privilege level 15. Optionally you may change or update the management IP of the FirePOWER module using the Setup Wizard. Launch and Log in ASDM using the ASA’s username and password. I recommend download a local copy of the ASDM client and use without going through the web browser every time. Here you may choose to install the ASDM client on your local computer or use Run ASDM directly from a Java-enabled browser. Step 2: Open a web browser and go to the management IP of the ASA You need first enable HTTP service and specify the network and interface where access is allowed. Configure and Manage ASA FirePOWER Module using ASDM Preparationīy default, HTTP service is not enabled on the ASA. As mentioned previously, there are two ways to configure and manage ASA FirePOWER module using ASDM and FirePOWER Management Center.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |